Connect with FloraCraft → Connect with FloraCraft at Facebook Connect with FloraCraft on TwitterFollow FloraCraft on PinterestFollow FloraCraft on InstagramWatch FloraCraft on YouTuber

Scandinavian “Let It Snow” Wreath

Browe Project Categories
Designed by Make It Fun Crafts
| More

Materials:  Let_it_snow_Wreath

FloraCraft® Make It: Fun® Foam:
Wreath: 16”

Other Materials:
45×8” Jersey Fabric: Red
48×6” Rolled Quilt Batting
Sequins: White
Sequin Pins
Yarn: White
(3) Canvas Tags: White
½” Ribbon: White
Marker or Paint Pen: Black

Low-Temp Glue Gun


  1. Wrap the batting around the front and sides of the wreath to completely cover. Trim so that the ends meet but do not overlap. Trim the batting even with the back edge of the wreath.
  2. Wrap the jersey fabric over the wreath in the same way. Allow for a 1” overhang around the outside of the wreath. Begin gluing the overhang to the back of the wreath. Keep the fabric even around the wreath as you go. Glue the end again where you stop slightly overlapping the fabric.
  3. Pull the fabric snug through the inside of the wreath and wrap to the back. Glue the fabric around the back edge as you go. Pull out as many wrinkles as possible. Pleat the fabric evenly around the wreath for a uniform look.
  4. Begin pinning the sequins in place as shown to look like falling snow. Pin the sequins sporadically towards the top of the wreath. Pin them thicker and more condensed as they accumulate at the bottom of the wreath.
  5. Use a marker or paint pen to write your message on the canvas tags. Tie lengths of yarn to the tags and sequin pin them hanging from the inside of the wreath. Tie lengths of ribbon around the yarn at the top of the tags to embellish.


One Comment

  1. Elizabeth Boettcher
    Posted September 26, 2016 at 2:29 pm

    Awesome crafts for me and the grand kids to have a fun days.

Post a Comment

Your email is never shared. Required fields are marked *