Decorative Mesh Wreath-Spring

Skill Level: Beginner

Write a Review

| More

Supplies

  • FloraCraft® CraftFōM®:
    • 16" Extruded Wreath - White
  • Decorative Mesh:
    • White
    • Purple
    • Hot Pink
  • Butterfly Picks
  • Ribbon:
    • 1" - Purple
    • 1/5" - Pink
  • Silk Flowers

Tools

  • Tie Wire
  • Floral Pins
  • Low-Temp Glue Gun and Glue Sticks
  • Scissors
  • Wire Cutter

Instructions

  1. Start at the inside edge of the wreath using the white decorative mesh.  Gather the end of the mesh together and pin it to the inside edge of the wreath.  Measure out about 10″ and gather the mesh again.  Loop the mesh and pin the gathered section about 2″ over from the first pin.  Continue gathering and pinning the mesh loops around the inside edge of the wreath to completely cover.  Cut the mesh where you stop and pin the end to secure.
  2. Gather and pin loops of the fuchsia mesh like you did the white.  Pin the fuchsia mesh around the front center of the wreath covering the front of the wreath completely.  Cut the mesh where you stop and pin the end to secure.
  3. Gather and pin loops of the purple mesh around the outside edge of the wreath in the same way.  Completely cover the outside edge of the wreath with purple.  Cut the mesh and pin the end where you stop.
  4. Make a large mult-loop bow with long tails from the 1-1/2″ pink ribbon.  Cut long tails from the 1″ purple ribbon.  Tie the 1″ tails to the bottom of the larger bow and attach the bow to the bottom of the wreath.
  5. Cut the stems of the flowers to about 4″ and insert them into the wreath around the bow.  Attach the butterflies to the flowers.  Remove and add low-temp glue to secure.

 

 

Leave a review or ask a question