Connect with FloraCraft → Connect with FloraCraft at Facebook Connect with FloraCraft on TwitterFollow FloraCraft on PinterestFollow FloraCraft on InstagramWatch FloraCraft on YouTuber

Witchy Boo!

Browe Project Categories
Designed by Make It Fun Crafts
| More

As seen in Crafts ‘n Things

Supplies

FloraCraft®

Make It: Fun® FloraCraft® Foam: Cone, 3 7/8″ x 11 7/8″
Design Master® ColorTool® Spray Color: Olive Bright, Flat Black
12″ x 12″ Cardstock: White, purple stripe and orange
Buttons: Two 1″ diameter white and four 1/2″ diameter black
Paper shreds, small amount black

Tools:
Elmer’s® CraftBond™ Tacky Glue
X-ACTO® Products:
+ #11 Craft Knife
+ 12″ Metal Ruler
+ 5″ Precision Tip Scissors
Glue gun and glue sticks
Compass
Pencil
Copy paper
Newspapers

Instructions

  1. In well-ventilated, newspaper-covered area, spray top third of foam cone black. Let dry. Spray bottom two thirds cone green. (Note: It’s not necessary to mask off area, hair will cover slight overspray.) Spray both sides of white cardstock with green spray color.
  2. For hat brim, use compass (or trace around bowl) to draw 6 1/2″ circle onto “Candy Circles” paper. Similarly draw 2 1/2″ circle in center. Cut out outer and inner circle with scissors. Set aside.
  3. Trace and cut out nose and ear patterns on green and mouth pattern on orange cardstock.
  4. For the moment, place nose flat against cone, approx 2″ from bottom and use craft knife to cut 1/4″ deep vertical slit into cone, along straight edge of nose. Insert nose into slit. Similarly position and cut slits for ears, then insert. Then remove each, dot with tacky glue, and re-insert into slits.
  5. Slightly crumple mouth. Referring to photo, hot glue ends of mouth in place. Hot glue black button on lower half of white button with edges touching. Repeat for other eye and glue in position. For wart, glue black button to each side of nose bump.
  6. Carefully, slightly crumple hat brim for a crunched look. Place hat brim on head and tack glue if loose. For hair, gently knead paper to intertwine strands and tack onto head using glue gun. For bangs, fold 2 strands at a time in half and glue under hat. Repeat to cover bang area, then trim bangs as desired.

 

For pattern, click the image to enlarge

 

 

 

 

Sources

FloraCraft®
(800) 253-0409
One Longfellow Place
Ludington, MI 49431
www.floracraft.com

Design Master®
(303) 443-5214
P.O. Box 601
Boulder, CO 80306
www.dmcolor.com

Elmer’s® Products, Inc.
(888) 435-6377
460 Polaris Pkwy. Ste. 500
Westerville, OH 43082
www.elmers.com

Post a Comment

Your email is never shared. Required fields are marked *

*
*