Connect with FloraCraft → Connect with FloraCraft at Facebook Connect with FloraCraft on TwitterFollow FloraCraft on PinterestFollow FloraCraft on InstagramWatch FloraCraft on YouTuber

Sweetheart Wreath

Browe Project Categories
Designed by Make It Fun Crafts
| More

Supplies

FloraCraft® Foam:
Extruded Wreath: 8” White

Other Materials:
Design it:® SimpleStyle® Decorative Mesh: Hot Pink
Design it:® SimpleStyle® Aluminum Wire: Purple
Ribbon: 1” Coordinating Color
Floral Pins

Tools:
Low-Temp Glue Gun
Scissors
Wire Cutters

Instructions

  1. Lay the wreath flat on the table.  Gather the end of the Decorative Mesh and pinch together. Pin the gathered end to the outside edge of the wreath.  Pin at the back edge to help conceal the pins and cover the wreath completely.
  2. Measure out about 8” from the end and gather and pinch together again at this spot.  Make a loop across the front of the wreath with this 8” section, keeping the mesh pinched at the 8” mark.  Pin the pinched mesh at the inside edge of the wreath, just across from where you pinned the end on the outside.
  3. Continue measuring out 8” at a time and alternating the pinning from the outside edge to the inside edge of the wreath.  Continue until you have looped the mesh all the way around the wreath.  Cut the mesh at the end and gather and pin the end in place.
  4. Cut a length of Aluminum Wire using the wire cutters.  Shape the wire into a heart leaving about a 1” end for inserting into the wreath.  Glue the heart in place.
  5. Cut a length of ribbon to create a hanger.  Loop it through the wreath and glue the ends together to secure.

Post a Comment

Your email is never shared. Required fields are marked *

*
*