Connect with FloraCraft → Connect with FloraCraft at Facebook Connect with FloraCraft on TwitterFollow FloraCraft on PinterestFollow FloraCraft on InstagramWatch FloraCraft on YouTuber

Spring Flowers Mesh Wreath

Browe Project Categories
Designed by Make It Fun Crafts
| More

Supplies

FloraCraft® Foam:
Wreath: 18” Green

Other Materials:
Design It: ® Simple Style® Decorative Mesh: White
Design It: ® Floral Pins
Ribbon: Blue Stripe

Tools:
Design It: ® Wire Cutter
Low-Temp Glue Gun
Scissors

Instructions

  1. Gather the end of the mesh together and pin the gathered end to the outside of the wreath at the back edge.  Leave the back of the wreath bare so that it will lay flat against the wall or door when hung.
  2. Measure out about 10” from the pinned end and gather again.  Pin this gathered section to the inside of the wreath at the back edge.
  3. Measure out another 10” from this point and gather again.  Pin this gathered section again at the outside of the wreath next to the first pin.  Continue gathering and pinning the mesh at the inside and outside edges all the way around the wreath.  Cut the mesh where you stop and pin the end in place.
  4. Cut the flower stems to about 5”.  Insert the flowers into the wreath between the loops of the mesh.  Add glue to the stems before inserting for a more secure hold.  Glue the leaves in place around the flowers to help fill in.
  5. Cut the ribbon into 12” lengths.  Use your scissors to dovetail both ends of the ribbon lengths. Pin the center of the ribbons to the wreath to fill in around the flowers.

Post a Comment

Your email is never shared. Required fields are marked *

*
*