Connect with FloraCraft → Connect with FloraCraft at Facebook Connect with FloraCraft on TwitterFollow FloraCraft on PinterestFollow FloraCraft on InstagramWatch FloraCraft on YouTuber

Sorbet Mesh Wreath

Browe Project Categories
Designed by Make It Fun Crafts
| More

As seen at JoAnn’s stores

Supplies

FloraCraft┬« Extruded Foam Wreath: 10″
Design It: Simple Style┬« 10″ Decorative Mesh: Orange Ombre
Floral pins
Scissors
Ruler

Instructions

  1. Gather the end of the mesh together tightly. Pin the gathered end to the inside edge of the wreath. Measure out 8″ and gather the mesh together again at this point. Loop the mesh and pin the gathered portion 2″ apart from the first pin. Continue measuring, looping and pinning on around the inside edge of the wreath. Cut the mesh, gather the end and pin again.
  2. Gather and pin the end of the mesh to the face of the wreath. Measure out 10″ and gather again. Make a loop and pin this gathered section to the wreath 2″ apart from the first pin. Continue measuring, looping and pinning the mesh on around the face of the wreath to point of start. Cut the mesh, gather the end and pin in place.
  3. Gather and pin the end of the mesh to the outside edge of the wreath. Measure out 10″ and gather again. Make a loop and pin this gathered portion to the wreath 2″ apart from the first pin. Continue measuring, looping and pinning around the outside edge of the wreath. Secure the mesh.

One Comment

  1. Barbara Mathes
    Posted March 14, 2016 at 9:51 am

    Thank you very much for such a quick response. The directions sound a little complicated but I’m sure it’ll be beautiful once I start on it.

Post a Comment

Your email is never shared. Required fields are marked *

*
*