Connect with FloraCraft → Connect with FloraCraft at Facebook Connect with FloraCraft on TwitterFollow FloraCraft on PinterestFollow FloraCraft on InstagramWatch FloraCraft on YouTuber

Skeleton Hand Centerpiece

Browe Project Categories
Designed by Make It Fun Crafts
| More

Supplies

FloraCraft® Foam:
Sheet: 1” x 12” x 18”
Discs: 4” x 1” and 6” x 1”
Ball: 3”

Other Materials:
Duct Tape: White and Black
Acrylic Paint: Black and White
Silk Roses: Black w/Glitter
Halloween Garland: Black w/ Glitter
Toothpicks

Tools:
Low-Temp Glue Gun
Design It:® Foam Cutter or Serrated Knife
Scissors
Wire Cutters
Paint Brush
Black Marker

Instructions

  1. Cut the individual bones using the Foam Cutter or serrated knife.  The middle finger is about 6” long x 1” wide to the pointer finger and the ring finger are about 5” long x 1” wide and the pinky finger and the thumb are about 4” long x 1” wide.  The two forearm bones are cut with a slight bow or curve like this () and are about 9” long x 1.25” wide.  Cut the 3” ball in half and use half a ball for the palm of each hand.
  2. Use a scrap piece of foam as a sanding block to round the tip of each finger; leave the opposite end of the fingers flat.  Measure 1” down from the end of each finger and the thumb and draw a line.  Measure 1.5” down from this line and draw another line on each finger, not on the thumb.    Cut the fingers and the thumb apart at each line but keep the parts together so the fingers don’t get mixed up.  Glue the finger parts back together so that they bend up as shown.  Glue the forearm parts together side by side like this ().  Glue the rounded side of the half ball to the top of the forearm.  Glue the fingers in place around the palm.
  3. Cover the hand and forearm with white duct tape.  Pinch and twist wrinkles in the tape as you wrap.  Repeat this process with black duct tape to cover the disc.
  4. Place a small amount of white acrylic paint on the plate.  Add a little paint to the brush and then wipe off excess paint so that the brush looks almost dry.  Lightly brush across the folds and wrinkles of the black tape allowing some of the black tape to show through.  Repeat using white black paint over the white duct tape.  Add more or less paint for your desired look.  Let dry.
  5. Glue the forearm to the disc.  Glue a rose blossom to the palm of each hand and cut small sprigs of Halloween garland to glue around the roses.

Post a Comment

Your email is never shared. Required fields are marked *

*
*