Connect with FloraCraft → Connect with FloraCraft at Facebook Connect with FloraCraft on TwitterFollow FloraCraft on PinterestFollow FloraCraft on InstagramWatch FloraCraft on YouTuber

Quick Candle Ring Tree

Browe Project Categories
Designed by Make It Fun Crafts
| More

Supplies

FloraCraft® Brand Products:
Make It: Fun® STYROFOAM™ Brand Foam Cone, 3 7/8″ x 11 7/8″
Design It:® 6.5″ Wire Cutter

Berry candle rings: Three 3 1/4″ diameters and four 1 1/4″ diameters
Glass pedestal candleholder, 3 3/8″ x 3 1/2″

Instructions

  1. With Design It:® Wire Cutter, cut through ring of one large candle ring. Spread ring apart and place 1/2″ above bottom of STYROFOAM™ Cone. Hot glue in a few places to hold.
  2. Slide second large candle ring down onto cone till snug, about 3″ from bottom and similarly spot glue.
  3. With third large candle ring, use Wire Cutter to cut through ring and slide onto cone about 6″ from bottom. Overlap cut ends and hot glue in place. (Note: Candle rings will be about 2″ apart.)
  4. Continue in same manner with small candle rings, cutting to spread or overlap cut ring ends, as needed to fit cone and spot gluing in place.
  5. Bend and spread berries, leaves and candies to evenly distribute and fill out cone.
  6. Place cone on glass pedestal candleholder to display. Hot glue in place, if desired.

SOURCES

FloraCraft®
(800) 253-0409
One Longfellow Place
Ludington, MI 49431
www.floracraft.com

Post a Comment

Your email is never shared. Required fields are marked *

*
*