Connect with FloraCraft → Connect with FloraCraft at Facebook Connect with FloraCraft on TwitterFollow FloraCraft on PinterestFollow FloraCraft on InstagramWatch FloraCraft on YouTuber

Nativity Silhouette Decor

Browe Project Categories
Designed by Make It Fun Crafts
| More

Materials:  Nativity

FloraCraft® Make It: Fun® Foam:
Sheets: 1”x12”x18” and ½”x 12”x 12”

Other Materials:
Acrylic Paint: White and Gold
Glitter: Gold
Fine Glitter Dust: Iridescent and Gold
Spray Sealer: Clear
Craft Sticks
Toothpicks

Tools:
FloraCraft® StyroCutter® Plus
Low-Temp Glue Gun
Serrated Knife
Ruler
Sequin Pins
Monofilament Line

Nativity Template:

INSTRUCTIONS:

  1. Cut two 2”x 18” and two 2”x 12” pieces from the 1” foam sheet for the roof and walls. Cut one 4.5”x12” piece from the ½” foam sheet for the base. Lay the roof pieces on the 1” edge angled end to end to create the roof shape. Cut angles in the roof piece ends so that they come together flush at the peak of the roof. The bottom corners of the roof should measure about 24” apart. Glue the roof pieces together. Insert a toothpick between the pieces for added support.
  2. Lay the two wall pieces under the roof about 4” in from each end. Angle the walls in slightly at the bottom. The gap between the walls should be about 10.5” at the bottom. Lay the roof over the tops of the walls and trace the pitch of the roof on each wall. Cut the marked angles in the walls so they come together flush with the roof. Glue the walls in place. Insert a toothpick between the pieces for added support. Draw a line straight across the bottom of each wall piece so they stand flat against the table. Cut a ½” x ½” notch out of each inside corner of the walls. This is where you will insert and attach the base.
  3. Paint the roof and walls gold. While the paint is still wet sprinkle with gold glitter. The paint will secure the glitter in place as it dries. Once completely dry; spray with a clear sealer to help prevent glitter from flaking off.
  4. Cut out the paper templates and pin them to the remaining ½” foam sheet. Follow the instructions on the StyroCutter Plus packaging to cut the shapes from the foam. Paint the base and the Joseph, Mary and Baby Jesus silhouettes white. While the paint is still wet sprinkle with iridescent glitter.
  5. Crisscross two craft sticks under the baby silhouette. The foam cutout should nest between the craft sticks as shown. Glue to secure the craft sticks together. Paint the craft sticks and the star gold. While the paint is still wet sprinkle the craft sticks with gold glitter. Sprinkle the star with the fine gold glitter. Let dry completely.
  6. Glue the baby to the craft sticks. Press the craft sticks into the foam at the front of the nativity. Secure in place with glue. Glue the other two silhouettes standing on either side of the baby. Hang the star above the nativity with mono-filament line.

 

Holiday 16 Photography

Holiday 16 Photography

Holiday 16 Photography

Holiday 16 Photography

Holiday 16 Photography

Holiday 16 Photography

Holiday 16 Photography

Holiday 16 Photography

Holiday 16 Photography

Holiday 16 Photography

 

Post a Comment

Your email is never shared. Required fields are marked *

*
*