Connect with FloraCraft → Connect with FloraCraft at Facebook Connect with FloraCraft on TwitterFollow FloraCraft on PinterestFollow FloraCraft on InstagramWatch FloraCraft on YouTuber

Harvest Pods Arrangement

Browe Project Categories
Designed by Make It Fun Crafts
| More

Supplies

FloraCraft® Brand Products:
Design It:® :
Silks & Naturals® Desert Foam®, 7 7/8″ Half Ball
Floral Shears
Wire Cutter

11″ diameter x 7 1/2″ tall unfinished (raw) wood bucket
Design Master® ColorTool™ Spray Color: Orange and Glossy Wood Tone
Two 33″ length green and orange Eucalyptus leaves
30″ length long brown spiral twig
19″ length dark green grass bunch
Two 18″ length burnt orange Eucalyptus pods
Four 13″ length laurel berry sprays
Ruler
Glue gun and glue sticks
Cardboard box (for spraying)
Old newspapers

Instructions

  1. In well-ventilated, newspaper-covered area (inside box) lightly spray bucket two coats Orange. Then mist with Glossy Wood Tone to darken. Let dry.
  2. Place Silks & Naturals™ Desert Foam® Half Ball, flat side up in wood bucket, using glue gun to attach rounded surface to bottom. Press in place until firmly set.
  3. Insert dark green grass bunch in center of ball.
  4. Use Wire Cutter to cut tall spiral twig in half and insert on either side of grass. Trim blunt end to point.
  5. Also insert 18″ Eucalyptus on either side of grass. Use Wire Cutter to cut apart laurel berry sprays and insert leaves and pods, separately, throughout whole arrangement.
  6. Cut apart Eucalyptus leaf sprigs and randomly insert. (Note: There is no “front”, so keep turning arrangement as you add florals, so that it looks good from all sides.)
  7. Refer to photo to check arrangement so that it’s flowing from tall in center to shorter all around bucket. Adjust as needed. Allow some leaves to extend over side of bucket. Tip: if desired, lightly mist entire arrangements with Glossy Wood Tone, to blend colors.

Post a Comment

Your email is never shared. Required fields are marked *

*
*