Connect with FloraCraft → Connect with FloraCraft at Facebook Connect with FloraCraft on TwitterFollow FloraCraft on PinterestFollow FloraCraft on InstagramWatch FloraCraft on YouTuber

Decorative Fringe Trees

Browe Project Categories
Designed by Make It Fun Crafts
| More

SuppliesWhite & Gold Fringe Trees

Supplies listed will create the five trees as shown.

FloraCraft® Make it: Fun® Foam:
Cones: (4) 9” and (4) 6”
Balls: (5) 1”

Other Materials:
4” Fringe: (5 Yards) Gold, (4 Yards) White
(1/4 Yard) Gold Lamé Fabric
Acrylic Paint: Gold
Sequin Pins
Fine Gold Glitter
Jumbo Gold Glitter

Tools:
Low-Temp Glue Gun
Scissors
Paint Brush

Instructions

  1. To create the tallest gold tree, cut 3” off the top of a 9” cone using the serrated knife. Cut 3” off the bottom of a second 9” cone. Glue the 6” bottom section of one cone onto the top of the 3” bottom section of the other cone. Glue the 6” top section onto the top of the stacked bottom sections. Glue the 3” top to the top of the tree. (Stack order: 3” bottom, 6” bottom, 6” top, 3” top) Insert a toothpick between the pieces before gluing for a more secure hold. The middle sized gold tree is a 9” cone and the smallest gold tree is a 6” cone.
  2. Paint the cones gold and while it is still wet, sprinkle with fine gold glitter. The paint will hold the glitter in place as it dries. Paint three 1” balls gold and sprinkle with jumbo glitter. Set parts aside to dry.
  3. Starting at the bottom, leaving 3 inches showing, and working to the top of the cones, pin rows of gold fringe trim around the cones evenly spaced. Wrap each row of fringe around the cone three times to cover completely.       Glue the gold glittered balls to the top of the three gold trees.
  4. To create the tallest white tree, glue a 9” cone on top of a 6” cone. To create the small white tree, cut 1” off the top of a 6” cone for the base and glue a 6” cone on top.
  5. Wrap the bottom of the trees with the gold lamé fabric. Trim to fit with scissors and glue in place. Wrap two 1” balls with the lamé fabric and glue to secure in place.
  6. Pin rows of white trim to the trees the same way you did the gold trees, leaving the gold bases visible.       Glue the 1”, lame-covered balls to the tops of the white trees.

Post a Comment

Your email is never shared. Required fields are marked *

*
*