Connect with FloraCraft → Connect with FloraCraft at Facebook Connect with FloraCraft on TwitterFollow FloraCraft on PinterestFollow FloraCraft on InstagramWatch FloraCraft on YouTuber

Christmas Wall Art

Browe Project Categories
Designed by Make It Fun Crafts
| More

Supplies

FloraCraft® Foam:
Sheets: (2) 1”x 12”x 36”
Discs: (2) 10”x 1”

Other Materials:
16 oz. Deco Art® Snow Tex™
Acrylic Paint: Red, White
Glitter: Red
(2) Large Glittered Leaves: Red
(6) Glittered Leaves: Bright Green
(2) Glittered Poinsettias: Red
Natural Branches: Painted White
Holiday Print Ribbon: 2.5”, 1.5”, 5/8” (coordinating styles)
(6)Holiday Ornaments
Pins
Paper

Tools:
FloraCraft® Foam Tools
Low-Temp Glue Gun
Wire Cutters
Small Spatula or Wide Flat Brush
Scissors
Pencil

Instructions

  1. Use the spatula or brush to completely cover the front and sides of both foam sheets with Snow-Tex™.  Apply a thin solid coat for even coverage.  Set aside to dry.
  2. Search online for a font you like to spell “JOY” & “NOEL”.  Print and cut them out to use as templates.  Pin the letters centered onto the discs evenly spaced.  Use a pencil to trace around the letters.  Use the tuck tool from the Foam Tools and follow the pencil line to create an impression around the letters about 1/8” deep.  Now use the scribe tool with firm pressure to compress the foam.  Stay inside the lines you created with the tuck tool.  Paint the letters white with acrylic paint and let dry.
  3. Paint the fronts of the discs red and while the paint is still wet sprinkle with red glitter.  The paint will act as the glue and secure the glitter as it dries.  Once dry, glue 1” ribbon around the edges of each disc to finish then glue the discs to the front of the foam sheets.  Center the discs about 5” up from one end as shown.
  4. Cut lengths of the different widths of ribbons and glue them to the bottom of each sheet.  Overlap the ribbons to create interest.
  5. Glue a large, glittered, red leaf centered above each disc.  Use the top of the disc to arrange the stems and branches into.  Insert a few white branches into the disc in front of the red leaves.  Push the green leaves in at the base of the white branches on each side.  Push a red poinsettia in tight at the top of the disc then glue three ornaments next to the poinsettias.
  6. Cut two thicker white branches about 16” long to use for the hangers.  Attach the branch to the top of the sheet using 12” lengths of ribbon.  Glue and pin the ends of two pieces of ribbon spaced about 7” apart to the top back of the sheet.  Glue the opposite ends of the ribbons around the branches evenly spaced.

Post a Comment

Your email is never shared. Required fields are marked *

*
*