Connect with FloraCraft → Connect with FloraCraft at Facebook Connect with FloraCraft on TwitterFollow FloraCraft on PinterestFollow FloraCraft on InstagramWatch FloraCraft on YouTuber

Table Tree Favor

Browe Project Categories
Designed by Make It Fun Crafts
| More

Materials:

  • For One Table Favor:
  • FloraCraft® Brand Products:
  • STYROFOAM™ brand foam:
  • 1 Piece, 1″ x 2″ x 2″
  • 1 Cone, 2 3/8″ x 3 7/8″
  • Design It:® Foam Cutter
  • Papers used for this project from The Paper Company/TPC Studio:
  • 12″ x 12″ Gold Swirl on Ivory Scrapbook Paper
  • 12″ x 12″ Gold Shimmer Cardstock
  • 1 pkg. Self-Adhesive Wedding Jewels
  • 1 pkg. Gold Swirl on Ivory Paper Stickers
  • 8″ length gold rick rack
  • 8″ length gold/copper beaded trim
  • 1″ Gold mini spiral clip
  • Copper gel pen
  • 4″ length of 3/16″ diameter wood dowel
  • 1 sheet copy paper
  • Extra Strength Glue Stick (Elmer’s® Craft Bond™)
  • Glue gun and glue sticks
  • Scissors
  • Toothpick
  • Straight pin
  • Ruler
  • Pencil
  • Transparent tape
Instructions:
  1. To make party favor pattern: wrap copy paper around cone, overlapping until cone is covered. Temporarily tape to hold. Trim away excess paper. Snip 1/2″ point off top. Remove tape and paper from cone and use for pattern.
  2. Trace and cut pattern onto gold swirl scrapbook paper and cut out. Set aside.
  3. Hot glue trim of beaded trim along bottom edge of cone.
  4. Use glue stick to wrap scrapbook paper around cone and glue overlapping edge at back. Trim top point to 1/4″.  Apply hot glue to cone top, finger gather paper and press down.
  5. Use glue stick to attach rick rack near bottom of tree cone.
  6. For base, use foam cutter to cut a 1″ x 2″ x 2″ square from STYROFOAM* .
  7. Cut 1 1/8″ x 8 1/4″ strip and two 2″ square pieces from gold cardstock.  Wrap strip around base, starting at back. Remove strip and crease corners. Apply glue stick to STYROFOAM* and re-wrap strip, overlapping ends at back.  Glue gold squares to top and bottom of base. Use glue stick to attach rick rack to top edge of base.
  8. Insert dowel into bottom of tree cone. Remove and place hot glue into hole. Reinsert dowel. Use toothpick to make starter hole in paper in center of base. Glue and insert dowel.
  9. Keeping backing on sticker, trim around paper sticker. Use copper gel pen to write name on sticker. Insert sticker into mini swirl clip. Use pin to make starter hole at tip of tree, insert and glue mini swirl clip. Attach self-adhesive jewels to tree, base and tag.

Repeat to make additional party favors for other guests.

Post a Comment

Your email is never shared. Required fields are marked *

*
*