Connect with FloraCraft → Connect with FloraCraft at Facebook Connect with FloraCraft on TwitterFollow FloraCraft on PinterestFollow FloraCraft on InstagramWatch FloraCraft on YouTuber

Baby Shower Centerpiece

Browe Project Categories
Designed by Make It Fun Crafts
| More

Supplies

MATERIALS:

FloraCraft® Brand Products:
Gala® Bouquet Holder, 4″ x 9 3/4″, crystal handle
FloraCraft® Foam white Ball, 4″
1/2 yd. white tulle

Ribbon:
3 yd. length of 1/4″ wide white picot-edged
1 yd. 12″ length of 1/2″ wide white and pink heart
1 yd. 12″ length of 3/8″ wide pink polka dot
1 yd. 12″ length of 1/4″ wide pink gingham
14″ length of 5/8″ wide pink and white stripe

Twenty 1 1/2″ diameter pink and white sheer flowers

Elmer’s Products;
CraftBond™ Glue Tape Runner
CraftBond™ Tacky Glue
X-ACTO® 5″ Precision Tip Scissors
Rotary cutter, cutting mat and acrylic ruler

Craft pick (or something to make small holes)
Paper plate

Instructions

  1. Carefully remove top of crystal section and green foam ball from Gala Bouquet Holder™. Set aside green foam ball for future use. Replace with white STRYOFOAM™ ball, using tacky glue to secure in place. Reassemble Gala Bouquet Holder™.
  2. Use rotary cutter on cutting mat and acrylic ruler to cut eight 2″ wide strips of tulle. Similarly cut each strip into 2″ squares.
  3. To attach tulle square, use craft pick to make a small hole into STRYOFOAM™ ball; squeeze tacky glue into hole and use craft pick to push double layer of tulle into hole. Give pick a little twist before removing. (Tip: Start in lower sections of holder working up to top of ball.) Continue until all sections are covered.
  4. Use scissors to cut two 24″ lengths white picot-edged ribbon and set remainder aside. Cut all pink ribbons into 24″ lengths, except 14″ length of pink and white stripe. Apply tape runner to ribbon and attach, going from center band vertically down one spoke to base of handle. (Note: It may be necessary to separate tulle to reveal spoke.) Repeat to attach ribbons to all vertical spokes, alternating ribbon type.
  5. Apply tape runner to pink and white stripe ribbon and attach to center band of holder. Trim ends. Gather all ribbons around base of handle and use remaining length white picot edge ribbon to wrap and tie into bow. Trim ends of ribbons to various lengths.
  6. Refer to photo and attach flowers to centerpiece and ribbons with tacky glue.

SOURCES

FloraCraft®
(800) 253-0409
One Longfellow Place
Ludington, MI 49431
www.floracraft.com

Click here for online shopping for the Gala® Bouquet Holder

Elmer’s® Products, Inc.
(888) 435-6377
460 Polaris Pkwy. Ste. 500
Westerville, OH 43082
www.elmers.com

Post a Comment

Your email is never shared. Required fields are marked *

*
*